Owens Corning Roof Inspection Nationwide

Owens Corning Roof Inspection in West Palm Beach: What to Know First

We provide independent Owens Corning roof inspection across West Palm Beach, typically completing a full assessment in 60 to 90 minutes with a written report and photos in hand before we leave the property. Inspection pricing runs $195 to $325 depending on roof size, slope, and accessibility, and that number goes on paper before any work starts, always. No exceptions.

Call (728) 203-3066

This page is for homeowners in West Palm Beach who own a home with Owens Corning shingles, underlayment, or a complete Owens Corning system and want a straight answer about what’s happening up there. If the roof is leaking, lifting, granulating, or just aging, call (728) 203-3066 and a live person answers. Always.

How Owens Corning Products Fail, and How We Fix Them

Owens Corning builds a solid product line, but every roof in West Palm Beach answers to the same sun, humidity, and storm cycles. Here’s what we actually see on Owens Corning roofs in this market, series by series, and what we do about it.

• Duration Series granule shedding in the first five years. Duration and Duration STORM are the Owens Corning lines we see most often in West Palm Beach. The symptom owners notice first is granules collecting in gutters or washing down the driveway after a hard rain. The real cause is usually not a manufacturing defect but improper installation, typically nails driven too high or too shallow, which lets shingle tabs flutter in wind and scrub granules off. Our fix is a full fastener audit: we check nail placement on a representative sample across every roof plane, then correct what’s found before new shingles go down.
• Oakridge uplift at the rake edges after thunderstorms. Oakridge is a common spec on mid-range West Palm Beach homes, and the weak point is the rake edge where the shingle meets the fascia. West Palm Beach gets driving rain off the Atlantic side, and if the starter course wasn’t set with the right overhang or the drip edge wasn’t nailed tight, those edge shingles lift and crack. During an inspection we pull back a section at each rake if the roof is accessible, check the starter row, and document whether the drip edge was set against the decking or floated. That detail determines whether the repair is a ten-minute fix or a symptom of a larger install problem.
• Decking rot under Owen Corning’s older Supreme line in Northwood Hills. Supreme was Owens Corning’s economy 3-tab, and we still find it on older flat-roof and low-slope homes in neighborhoods like Northwood Hills. The failure is rarely the shingle itself; it’s the decking underneath. West Palm Beach humidity works through any gap in the underlayment, and by the time a 3-tab roof is 12 to 15 years old here, the plywood underneath is often spongy. A visual-only inspection misses that. We probe decking with a moisture meter at every suspect zone and flag soft wood before it becomes a leak that ruins ceiling drywall.
• VentSure ridge vent separation on high-humidity days. Owens Corning’s VentSure ridge vent gets specified on a lot of West Palm Beach re-roofs. What we see after a few seasons is the filter material pulling away from the vent channel, usually because the installer used staples instead of ring-shank nails at the recommended spacing. When that happens, hot attic air stops moving and the shingle warranty quietly loses its teeth, because Owens Corning, like most manufacturers, ties the warranty to adequate ventilation. Our inspection documents attic ventilation with photos and temperature readings, not guesswork.
• WeatherLock underlayment failures at valleys and sidewalls. WeatherLock is Owens Corning’s self-adhered underlayment, and it’s a genuinely good product when it’s installed with the release film fully removed and pressure applied across the entire roll. What we find in West Palm Beach is valleys where the installer left the film in place along the edges, or sidewalls where the membrane wasn’t run high enough. The result is water getting behind the flashing and walking down the underlayment until it finds a seam. During inspection we check valley depths, sidewall height, and adhesion at every transition point on the roof.

Our Owens Corning Roof Inspection Process

Every Owens Corning inspection we do in West Palm Beach follows the same written sequence. You’ll know what we’re doing at each step, and you’ll have the findings on paper before we drive off.

1. 1
   Call and schedule. You call (728) 203-3066. A live person answers, takes your address, asks what prompted the call, and sets a window. Our technician shows up inside that window, in uniform, background-checked.
2. 2
   Ground-level walk and exterior assessment. We start on the ground: we look at the eave line, the gutter runs, the fascia, the sidewalls, and the roof’s overall plane. We’re looking for signs of sag, missing shingles, lifted edges, and granule buildup in gutters, all from before we ever put a ladder up.
3. 3
   Full roof surface inspection. We ladder up when it’s safe and walk the roof plane by plane. On Owens Corning roofs, we check nail placement, seal strip adhesion, shingle overlap, and the entire perimeter for wind damage. We photograph everything, including what we don’t find.
4. 4
   Flashing, penetration, and ventilation detail work. We check roof-to-wall flashings, pipe boots, chimney counter-flashing, skylights, and every valley. Then we go into the attic if it’s accessible and check intake and exhaust ventilation, decking condition, and any moisture staining along the ridge, eaves, and sidewalls.
5. 5
   Written report with photos and line-item findings. Everything we found goes onto paper: each issue with a photo, what’s causing it, what we recommend, and what it costs to fix. No verbal-only summary, and no estimates whispered from the ladder.
6. 6
   If there’s a repair, we quote it. If it’s clean, we say so. Not every inspection ends in a repair, and that should feel honest, not strange. If something needs work, you get a written price before any work starts. If the roof is clean, we tell you that, and we tell you what to watch for over the next season.

What Owens Corning Roof Inspection Costs in West Palm Beach

Inspection pricing in West Palm Beach runs $195 for a standard single-story home up to about 2,000 square feet of roof area. A two-story home or a roof with multiple slopes and complex flashing typically runs $275 to $325, because the work takes longer and the safety setup is different. If you have a flat-roof section or a tile roof with an embedded Owens Corning underlayment, we quote that separately after seeing the property.

What moves the price: roof height and pitch, number of planes, accessibility of the attic, and whether you need the inspection for a real estate closing, which requires extra documentation for the disclosure package. Repairs found during an inspection are quoted separately, in writing, with each line item priced before any work begins. Call (728) 203-3066 for an exact inspection quote. Estimates are free, and the price doesn’t move at the door.

Why West Palm Beach Homeowners Call Brennan Roofing Co West Palm Beach for Owens Corning Work

We’re an independent Owens Corning service provider, not an Owens Corning authorized contractor, and we think that’s the right relationship to have. Our job is to tell you what’s happening on your roof, not to protect a manufacturer’s warranty program or move a quota of replacement shingles. That independence is the reason Travis Oakley, our owner, insists on written findings with photos every single time. If the roof is fine, you’ll know that. If it’s not, you’ll know exactly what’s wrong and what it costs.

Our guarantees are simple and stated clearly. Every repair and installation is covered by the 365-Day Done Right Promise: it’s in writing, it runs for one full year, and if it fails within that period, we come back and make it right at no charge. Our technicians are background-checked and show up in uniform. You know who’s on your roof. And when you call, a live person answers, 24/7, no voicemail and no callback queue.

If your Owens Corning roof has reached the point where replacement makes more sense than repair, we’re not limited to one brand. We install materials from GAF, CertainTeed, Owens Corning, IKO, Atlas, Tamko, and Boral, and we’ll walk you through the options in plain dollars and plain terms. A roof done right doesn’t ask for your attention until it’s time for a new one. Until then, we’re here to keep yours straight.

FAQs